How Can We Help You?
AAMA 503-14:
Field Testing of Newly Installed Storefronts, Curtain Walls, and Sloped Glazing Systems

AAMA 503-14: Evaluating the Performance of Newly Installed Storefronts, Curtain Walls, and Sloped Glazing Systems

During AAMA 503-14 field testing, the performance and installation of storefronts, curtain walls, and sloped glazing systems are evaluated during the construction phase of a building and must be completed no later than six months after issuance of the occupancy. The testing is used to determine the performance of storefronts, curtain walls, and sloped glazing systems in resisting water penetration under controllable and reproducible test conditions that simulate wind-driven rain events. The AAMA 503-14 testing is also used to evaluate air leakage of “punched opening” curtain walls, storefronts, and sloped glazing systems.

Conducting AAMA 503-14 Evaluation Testing

If air leakage and water leakage evaluation testing is going to occur, then the air leakage must be tested before the water penetration resistance test takes place. If the tester believes there is residual water located inside of the testing area, then a two-minute negative pressure test followed by a two-minute positive pressure test needs to be conducted to purge the specimen of any residual water.

The purpose of the air leakage test is to measure the exterior air leaking through the joints, fixed glazing, hardware, etc within the area enclosed by the testing frame. During AAMA 503-14 testing, air leakage is determined by applying a blank (typically, thin plastic sheeting) over the testing area. The air passing through the testing area without the blank is calculated and subtracted from the amount of air leakage with the blank. Doing this removes extraneous air leakage for the results of the evaluation. The purpose of the water penetration test is to observe all possible points of water penetration. Defined as any water that is not contained in an area with provisions to drain to the exterior, water penetration is tested on the exterior plane.

The Benefits of AAMA 503-14 Testing from TSI Energy Solutions

TSI uses the latest testing technologies to ensure accurate procedures and precise results.   TSI’s technicians travel the country testing many types of systems under various climactic conditions which gives us the critical knowledge and experience necessary to perform these tests.

TSI Energy Solutions Expertise in AAMA 503-14 Testing

TSI’s testing team performs inspections throughout the country so we see various types of construction in all conditions.  TSI has tested hundreds of commercial buildings over our 35 plus year history.   Most of our technicians have been with our company for 10-25 years so they offer unrivaled experience.

How To Get Started with AAMA 503-14 Testing

At TSI Energy Solutions, our experts know how important it is to build a safe and secure building. We work with contractors, building managers, and owners to maintain standards. We make conducting AAMA 503-14 test as easy as possible.

Step 1: Provide TSI Energy Solutions with your contact information and a few details about the project you are working on by completing the form.

Step 2: Identify the testing area on our newly constructed building to be tested.

Step 3: Watch as our experts evaluation the water and air penetration resistance of your building.

Fields marked with an * are required